Стандарты для новых предприятий по производству краски на водной основе

This standard specifies the varieties, technical requirements, test rules and marking, packaging, transportation and storage of new water-based inks for flexographic printing.

This standard applies to water-based inks obtained by compound grinding and processing with water-soluble resin as the main raw material, with pigments, fillers and additives added, and the products can be widely used in the flexographic and gravure printing fields of printing and packaging for food, tobacco and alcohol, pharmaceuticals, cosmetics, children's toys and the like.

ink, and the products can be widely used in the flexographic and gravure printing fields of printing and packaging for food, tobacco and alcohol, pharmaceuticals, cosmetics, children's toys and the like.

1. Normative references

The clauses contained in the following standards constitute the clauses of this standard through citation in this standard. At the time of publication of this standard, the versions shown were all valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards.

ZAB17005 Classification, nomenclature and type designation of printing ink products

GB/T1723—1993 Test method for coating viscosity

GB/T13217.5－1991 Standard test method for gravure plastic inks — initial dryness test

GB/T14624.1－1993 Test method for ink color

GB/T14624.2－1993 Test method for ink tinting strength

QB559－1983 Test method for ink fineness

QB568－1983 Test method for ink resistance to ethanol, alkali, acid and water

QB567－1983 Test method for ink stability

QB573－1987 Test method for ink gloss

1. Product classification

According to product color, spot colors can be prepared as required, and their type designations conform to the requirements of ZBA17005.

1. Technical requirements

The technical indexes of this product shall conform to the following requirements:

Item/Index:

Color / approximately the standard sample

Fineness (um) / ≤20

Tinting strength (%) / 90-110

Viscosity (coating No. 4 cup, seconds /25℃) / 50±30

Initial dryness (cm) / 30-50

Alkali resistance, water resistance / good

Storage stability (5-30℃) / good

Gloss (reflection gloss meter 60℃) / >40%

1. Test methods

5.1 Color is tested in accordance with the method specified in GB/T14624.1.

5.2 Tinting strength is tested in accordance with the method specified in GB/T14624.2.

5.3 Fineness is tested in accordance with the method specified in QB559.

5.4 Viscosity is tested in accordance with the method specified in GB/T1723.

5.5 Initial dryness is tested in accordance with the method specified in GB/T13217.5.

5.6 The alkali resistance and water resistance of the ink are tested in accordance with QB568. The specific test method is: take printed samples after thorough drying and immerse them respectively in 1% sodium hydroxide and in water, take them out after soaking for 24 hours, and compare the changes with the color sample.

5.7 Storage stability is tested in accordance with the method specified in QB567.

5.8 Gloss is tested in accordance with the method specified in QB/T573.

1. Inspection rules

6.1 Before the product leaves the factory, it shall be inspected by the inspection department of the manufacturing plant, and it may leave the factory only after passing inspection and with a certificate of conformity attached.

6.2 The factory inspection items are color, fineness and viscosity.

6.3 Type inspection shall be carried out when one of the following situations occurs.

——This article is reprinted from China Packaging Network (pack.cn), original link: http://news.pack.cn/show-362234.html